Turning The Unit On/Off - Furuno 1833 Operator's Manual

1.3

Turning the Unit On/Off

Press the [POWER/BRILL] key to turn the unit on. A beep sounds and the
equipment proceeds in the sequence shown below, displaying the product
information screen, startup test results and the chart usage disclaimer. The
startup test checks the ROM, RAM, internal battery and backup data for proper
operation, displaying the results for each as OK or NG (No Good). If NG appears
an appropriate message appears on the screen. For any NG, try to press any
key to go to the chart disclaimer screen, then perform the diagnostic test
referring to the paragraph "7.5 Diagnostics."
Chart List
Host Name
RADAR PLOTTER
STATION NAME:
RADAR
FURUNO ELECTRIC CO., LTD.
CHARTS AVAILABLE
LICENSE NO.
Product information
The magnetron takes from one minute to two minutes and thirty seconds
(depending on radar model) to warm up before the radar can be operated. The
time remaining for warm up of the magnetron is counted down at the center of
the display.
You may press any key at the chart disclaimer screen to show the last-used
display, or wait several seconds to let the equipment do it for you.
To turn the unit off, press and hold down the [POWER/BRILL] key until the
screen goes dark (approx. 3 sec.). To protect the LCD attach the hard cover.
Note that the network sounder will be turned off approx. three minutes after
turning off the power.
Note: The first time you turn on the power (or any time the power is applied after
a memory reset), you are asked if you want to start the simulation mode,
which provides simulated operation of the equipment. Push the [ENTER]
knob to start the simulation mode, or press the [CLEAR] key to start
normal operation. For further details about the simulation mode, see the
paragraph "1.10 Simulation Display."
STARTUP TEST
ROM
RAM
è
BACKUP DATA
INTERNAL BATTERY
Startup test
Startup sequence
1. OPERATIONAL OVERVIEW
OK
OK
è
OK
OK
Chart disclaimer
1-7