Interpreting The Sounder Display; Zero Line; Bottom Echo - Furuno 1833 Operator's Manual

4.12

Interpreting the Sounder Display

4.12.1

Zero line

The zero line (sometimes referred to as the transmission line) represents the
transducer's position, and moves off the screen when a deep phased range is
used.
4.12.2

Bottom echo

Echoes from the bottom are normally the strongest and are displayed in the
darkest tone, but the tone and width will vary with bottom composition, water
depth, frequency, sensitivity, etc.
In a comparatively shallow depth, a high gain setting will cause a second or
sometimes a third or a fourth echo to be displayed at the same interval between
them below the first echo trace. This is because the echo travels between the
bottom and the surface twice or more in shallow depths.
The tone of the bottom echo can be used to help determine the density of the
bottom materials (soft or hard). The harder the bottom, the wider the trace. If the
gain is set to show only a single bottom echo on mud, a rocky bottom will show a
second or third bottom return. The range should be chosen so the first and
second bottom echoes are displayed when bottom hardness is being
determined.
Intensity difference
in water depth
Second bottom
echo
Zero line
Zero line
Rock base
Mud and sand
Bottom echoes
4. VIDEO SOUNDER OPERATION
Shift
4-23