Table of Contents
Advertisement
1. Normal Measurement
Press the START button. Blood pressure is measured and data is stored
within the device. The device can store the last 120 sets of data in memory
for each user.
2. Recalling The Data
Press the MEMORY button to recall the data.
The average data of all the measurements is
displayed, as indicated in the figure at the
right.
Press the AM/PM button to recall the average
data during the AM or PM.
Press the
button to display each
measurement.
For details on recalling data, refer to
"Recalling Memory Data".
3. Clearing The Data
Press and hold the MEMORY button until the "
(memory) mark blinks to clear the stored data.
4. Measurement With The Desired Systolic Pressure
Refer to page 10 for the measurement with the desired systolic pressure.
5. Switching The Unit Of Temperature
In the clock setting mode, when the dashes in the
temperature displaying area are blinking, press the
11
button to select °C or °F. Then, press the clock
button or START button to return to the clock
display.
For details on the clock setting mode, refer to
"Adjusting The Built-in Clock" on page 7.
6. Switching The User
Slide the switch to either User 1 or User 2 as necessary.
Operation Mode
(Refer to page 12)
English 5
Press
the MEMORY button
Average (all)
Displays alternately
every 3 seconds
"
Select the unit of
temperature
User selector switch
Number of data
Advertisement
Table of Contents
