Removing Memory Module - Toshiba NB 100 User Manual

8. Seat the cover and secure it with one screw.
9. When you turn the computer on, it should automatically recognize the

Removing memory module

To remove the memory module, make sure the computer is in boot mode
then:
1. Turn the computer off and remove all cables connected to the
■
If you use the computer for a long time, the memory modules will
become hot. In this case, let the memory modules cool to room
temperature before you replace them.
■
Do not try to remove a memory module with the computer turned on or
turned off in standby and hibernation mode. You can damage the
computer and the memory module.
2. Turn the computer upside down and remove the battery pack (refer to
3. Remove one screw securing the memory module cover.
4. Lift off the cover.
5. Use a slender object such as a pen to press two latches on either side
6. Grasp the memory module by the sides and pull it out.
Do not touch the connectors on the memory module or on the computer.
Debris on the connectors may cause memory access problems.
User's Manual
Pushing the memory module down
total memory capacity. If it is not recognized, check the module's con-
nection.
computer.
Chapter 6, Power and Power-up
of the memory module to the outside. The memory module will pop
up.
Modes.)
Optional Devices
8-6