Sanyo XHS3632 Service Manual page 82

(H) Change the shift temperature in heating mode
If the indoor unit is installed at high location (ex. ceiling level), the thermostat tends to turn off at
heating mode because of the hot air temperature around ceiling level. In order to solve the
problem, the shift temp. (valid while heating only) is set when shipped from factory.
If the shift temp. is not enough (ex. the indoor unit is installed at position higher than 3 m), the
shift temp. can be set with remote controller from +1 to +10 deg (°C) <from +2 to 20 deg (°F)>.
manually as follows:
a Press the TEST / CHK button for more than 4 seconds.
Section
1
2
b In case of group control, if you want to change all units in group control collectively,
proceed next step remaining ALL displayed.
If you want to change a unit individually, select the indoor unit address (UNIT No.) with
UNIT button.
3
c Select the CODE No. 06 with
d Choose the shift temp with
4
e Press the SET button.
CODE No. 06, SET DATA and
f If you made a mistake, press the CL button.
g Finally, press the TEST / CHK button.
AIR FLOW
UNIT MODE
UNIT No.
R.C. No.
FLAP
SET TEMP.
CODE No.
TIMER SET
FAN SPEED
SETTING
SET DATA
SET CL
ON •
OFF •
TEST / CHK
,
AIR FLOW
UNIT MODE
UNIT No.
R.C. No.
FLAP
SET TEMP.
CODE No.
TIMER SET
SET TEMP.
FAN SPEED
SETTING
SET DATA
SET CL
ON •
OFF •
TEST / CHK
0365_M_I
, (SET TEMP) button.
( ) button.
EX:
UNIT No. 1–6
CODE No. 06
Shift temp. +5 deg (°C)
0366_M_I
change from flashing to ON state.
SETTING
– 82 –
4. Service procedures
<+10 deg (°F)>
SM830076