Sanyo XHS3632 Service Manual page 77

This picture shows the service check display.
UNIT No.
UNIT No.
1–1
R.C.
No.
Refrigerant
Circuit No.
Alarm message
c. A maximum of 4 alarm messages can be accessed by pressing either SET TEMP button
or as follows.
For example, if the last four alarm messages were, in order of occurrence from oldest to most
recent, P01, P02, P04, and most recently E01, then the display will be shown as below when
you press button four times. The 5th time you press
then the first message will be shown again.
1
UNIT No.
R.C. No.
CODE No.
CHECK
SERVICE
If there are no alarm messages, the display shows:
No.
CODE No.
CODE No.
CHECK
SERVICE
0358_M_I
MODE
Past
SET TEMP.
Present
Present
Past
FAN SPEED
0359_M_I
2
UNIT No.
R.C. No.
CODE No.
CHECK
SERVICE
Alarm message
– 77 –
4. Service procedures
NOTE Pressing CL (Clear) button will clear
all the service history.
... accessed in order of "Past
... accessed in order of "Present
button you can repeat the display,
3
UNIT No. UNIT No.
R.C. No. R.C.
CODE No.
CHECK
SERVICE
UNIT No.
R.C. No.
CODE No.
CHECK
SERVICE
Present".
Past".
4
No.
CODE No.
CHECK
SERVICE
0360_M_I
SM830076
Section
1
2
3
4