Table of Contents
Advertisement
VideoJet X40 SN
5.18
Advanced Mode: Picture Settings
You can set the video image of each camera to suit your requirements. The current video
image is displayed in the small window next to the slide controls as confirmation. Your
changes are effective immediately.
1.
2.
3.
Contrast (0...255)
You can use this function to adapt the contrast of the video image to your working
environment.
Saturation (0...255)
You can use this function to adjust the color saturation so as to make the reproduction of
colors on your monitor as realistic as possible.
Brightness (0...255)
You can use this function to adapt the brightness of the video image to your working
environment.
Low-pass filter (0...255)
You can use this function to filter very fine noise from the image. This reduces and optimizes
the bandwidth necessary for image transmission over the network. The image resolution may
be impaired.
The higher the value set with the slide control, the flatter the image signal. Check your setting
in the image window next to the slide controls.
Also observe the processor load indicator that appears at the top of the window near the
manufacturer's logo (see Section 8.6 Network Connection, page 114).
Bosch Security Systems
Click a tab to select the corresponding camera.
Move the slide control to the required position.
Click Default to reset all settings to their default value.
Installation and Operating Manual
Configuration Using a Web Browser | en
DOC | V4.0 | 2009.06
47
Advertisement
Table of Contents
