Advanced Mode: Alarm Connections - Bosch VideoJet X40 SN Installation And Operating Manual

VideoJet X40 SN
5.27

Advanced Mode: Alarm Connections

You can select how the VideoJet X40 SN responds to an alarm. In the event of an alarm, the
unit can automatically connect to a pre-defined IP address. You can enter up to ten IP
addresses to which the VideoJet X40 SN will connect in sequence in the event of an alarm,
until a connection is made.
Connect on alarm
Select On so that the VideoJet X40 SN automatically connects to a predefined IP address in
the event of an alarm.
By setting Follows input 1 the unit maintains the connection that has been automatically
established for as long as an alarm exists on alarm input 1.
NOTICE!
i
In the default setting, Stream 2 is transmitted for alarm connections. Bear this fact in mind
when assigning the profile (see Section 5.19 Advanced Mode: Encoder Profile, page 48).
Number of destination IP address
Specify the numbers of the IP addresses to be contacted in the event of an alarm. The unit
contacts the remote stations one after the other in the numbered sequence until a connection
is made.
Destination IP address
For each number, enter the corresponding IP address for the desired remote station.
Bosch Security Systems Installation and Operating Manual
Configuration Using a Web Browser | en
DOC | V4.0 | 2009.06
63