Picture Settings - Bosch VideoJet X10 Installation And Operation Manual

VideoJet X10
5.10

Picture Settings

You can set the video image of the camera to suit your requirements. The current video image
is displayed in the small window next to the slide controls as confirmation. Your changes are
effective immediately.
1.
2.
5.10.1 Contrast (0...255)
You can use this function to adapt the contrast of the video image to your working
environment.
5.10.2 Saturation (0...255)
You can use this function to adjust the color saturation so as to make the reproduction of
colors on your monitor as realistic as possible.
5.10.3 Brightness (0...255)
You can use this function to adapt the brightness of the video image to your working
environment.
5.10.4 Low-pass filter (0...255)
You can use this function to filter very fine noise from the image. This reduces and optimizes
the bandwidth necessary for image transmission over the network. The image resolution may
be impaired.
The higher the value set with the slide control, the flatter the image signal. Check your setting
in the image window next to the slide controls.
Also observe the processor load indicator that appears in the top left of the window near the
unit name (see Abschnitt 8.5 Processor Load, Seite 116).
Bosch Security Systems
Move the slide control to the required position.
Click Default to reset all settings to their default value.
Installation and Operating Manual
Configuration Using a Web Browser | en 37
V3.0 | 2007.09