46
en | Configuration Using a Web Browser
5.17
Advanced Mode: Video Input
You can activate the 75 Ohm terminating resistance for each video input of the
VideoJet X40 SN. The terminating resistance must be deactivated for the video signal to be
looped through. Every video input is closed at the time of delivery.
NOTICE!
i
The numbering follows the labeling of the video inputs on the actual unit.
75 Ohm termination
Select Off if the video signal is to be looped through.
Source type
To allow VCRs to be connected as a video source, you can change the characteristic of the
video source from the preset value of Camera to VCR. VCRs require a more tolerant setting
for the internal PLL as a result of jitter effects caused by the mechanical components of a
VCR.
NOTICE!
i
In some cases, selecting the VCR option can lead to an improvement in the video image even
with a camera connected.
DOC | V4.0 | 2009.06
Installation and Operating Manual
VideoJet X40 SN
Bosch Security Systems