Table of Contents
Advertisement
40
en | Configuration Using a Web Browser
1.
2.
3.
4.
5.
6.
7.
8.
9.
Time server IP address
The VideoJet X40 SN can receive the time signal from a time server using various time server
protocols, and then use it to set the internal clock. The unit polls the time signal automatically
once every minute.
Enter the IP address of a time server here.
Time server type
Select the protocol that is supported by the selected time server. Preferably, you should
select the SNTP server as the protocol. This supports a high level of accuracy and is required
for special applications and subsequent function extensions.
Select Time server for a time server that works with the protocol RFC 868.
5.13
Advanced Mode: Display Stamping
Various overlays or "stamps" in the video image provide important supplementary information.
These overlays can be enabled individually and are arranged on the image in a clear manner.
NOTICE!
i
The settings on this page apply to all camera inputs.
DOC | V4.0 | 2009.06
First check whether the correct time zone is selected. If it is not correct, select the
appropriate time zone for the system, and click the Set button.
Click the Details button. A new window will open and you will see the empty table.
Select the region or the city that is closest to the system's location from the list field
below the table.
Click the Generate button to generate data and enter it into the table.
Make changes by clicking an entry in the table. The entry is selected.
Clicking the Delete button will remove the entry from the table.
Select other values from the list fields below the table to change the entry. Changes are
made immediately.
If there are empty lines at the bottom of the table, for example after deletions, you can
add new data by marking the row and selecting required values from the list fields.
Now click the OK button to save and activate the table.
Installation and Operating Manual
VideoJet X40 SN
Bosch Security Systems
Advertisement
Table of Contents
