Advanced Mode: Picture Settings - Bosch VIP-X1XF Installation And Operating Manual

VIP X1 XF
5.18

Advanced Mode: Picture Settings

You can set the video image of the camera to suit your requirements. The current video image
is displayed in the small window next to the slide controls as confirmation. Your changes are
effective immediately.
1.
2.
Contrast (0...255)
You can use this function to adapt the contrast of the video image to your working
environment.
Saturation (0...255)
You can use this function to adjust color saturation in order to correct unnatural camera signal
colors.
Brightness (0...255)
You can use this function to adapt the brightness of the video image to your working
environment.
Low-pass filter (0...255)
You can use this function to filter very fine noise from the image. This reduces and optimizes
the bandwidth necessary for image transmission over the network. The image resolution may
be impaired.
The higher the value set with the slide control, the more high-frequency components are
filtered from the image. Check your setting in the image window next to the slide controls.
Also observe the processor load indicator that appears at the top of the window near the
manufacturer's logo (see Section 6.6 Processor load, page 101).
Low-pass filter (0...255)
You can use this function to filter very fine noise from the image. This reduces and optimizes
the bandwidth necessary for image transmission over the network. The image resolution may
be impaired.
The higher the value set with the slide control, the more high-frequency components are
filtered from the image. Check your setting in the image window next to the slide controls.
Bosch Sicherheitssysteme GmbH
Move the slide control to the required position.
Click Default to reset all settings to their default values.
Installation and Operating Manual
Configuration using a Web browser | en
DOC | V4.54 | 2011.09
45