Dell Studio Hybrid Service Manual page 8

3. Disconnect the cable attached to the LED.
Installing the Bottom Logo LED
1. Paste the LED between the clamps.
2. Reconnect the cable to the LED.
Installing the Bottom Logo Assembly
1. Align the slots on the logo bracket with the tabs on the chassis. Slide the logo bracket until it clicks into position.
NOTE: Ensure that the logo assembly cable does not get entangled during this procedure.
2. Replace the screw that secures the logo bracket to the chassis.
3. Replace the system board (see
4. Replace the front I/O panel (see
5. Replace the back panel (see
6. Replace the processor heat sink (see
7. Replace the drive cage (see
8. Replace the computer cover (see
Back to Contents Page
Installing the System Board).
Installing the Front I/O Panel).
Installing the Back Panel).
Installing the Heat Sink).
Installing the Drive Cage).
Installing the Computer Cover).