Dell Studio Hybrid Service Manual page 2

Table of Contents

Advertisement

Back to Contents Page
  Replacing the Back I/O Board
Dell™ Studio Hybrid Service Manual 
  Removing the Back I/O Board
  Installing the Back I/O Board
 
CAUTION:
Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
 Removing the Back I/O Board
 
1. Follow the procedures in
Before You
 
2. Remove the computer cover (see
 
3. Remove the drive cage (see
 
4. Disconnect the flex cable from the I/O board.
 
5. Remove the two screws that secure the I/O board to the back panel.
 
6. Gently lift the I/O board away from the back panel.
 Installing the Back I/O Board
 
1. Align the connectors on the I/O board to the slots in the back panel.
 
2. Replace the two screws and secure the I/O board to the back panel.
 
3. Reconnect the flex cable to the I/O board.
NOTICE:
Ensure that you remove all cables out of the way before replacing the drive cage.
 
4. Replace the drive cage (see
 
5. Replace the computer cover (see
Back to Contents Page
 
Begin.
Removing the Computer
Cover).
Removing the Drive
Cage).
Installing the Drive
Cage).
Installing the Computer
Cover).

Advertisement

Table of Contents
loading

Table of Contents