Dell Studio Hybrid Service Manual page 7

Back to Contents Page
Replacing the Bottom Logo Assembly
Dell™ Studio Hybrid Service Manual
Removing the Bottom Logo Assembly
Removing the Bottom Logo LED
Installing the Bottom Logo LED
Installing the Bottom Logo Assembly
CAUTION: Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
Removing the Bottom Logo Assembly
1. Follow the procedures in Before You
2. Remove the computer cover (see
3. Remove the drive cage (see
4. Remove the processor heat sink (see
5. Remove the front I/O panel (see
6. Remove the back panel (see
7. Remove the system board (see
8. Remove the screw that secures the logo bracket to the chassis.
9. Slide and lift the logo bracket away from the chassis.
Removing the Bottom Logo LED
1. Pry the LED away from the chassis using a screwdriver.
2. Lift the LED away from the chassis.
Begin.
Removing the Computer Cover).
Removing the Drive Cage).
Removing the Heat Sink).
Removing the Front I/O Panel).
Removing the Back Panel).
Removing the System Board).