Dell Studio Hybrid Service Manual page 32

Back to Contents Page
Replacing the RF Receiver Board
Dell™ Studio Hybrid Service Manual
Removing the RF Receiver Board
Installing the RF Receiver Board
CAUTION: Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
Removing the RF Receiver Board
1. Follow the procedures in Before You
2. Remove the computer cover (see
3. Remove the drive cage (see
4. Remove the front panel (see
5. Remove the screw that fastens the RF receiver board to the front of the chassis.
1 RF receiver board
6. Lift the RF receiver board away from the chassis.
NOTICE: Carefully note the routing of each cable before you disconnect it, so that you re-route the cable correctly. An incorrectly routed or a
disconnected cable could lead to computer problems.
7. Disconnect the cable that connects the RF receiver board to the system board.
Installing the RF Receiver Board
1. Follow the procedures in Before You
2. Connect the cable to the connector (J2) on the RF Receiver board.
3. Align the RF receiver board with the groove on the chassis.
4. Replace the screw that secures the RF receiver board to the front of the chassis.
5. Replace the front panel (see
6. Replace the drive cage (see
7. Replace the computer cover (see
Back to Contents Page
Begin.
Removing the Computer Cover).
Removing the Drive Cage).
Removing the Front I/O Panel).
2 cable
Begin.
Installing the Front I/O Panel).
Installing the Drive Cage).
Installing the Computer Cover).