Table of Contents
Advertisement
Back to Contents Page
Replacing the Front I/O Panel
Dell™ Studio Hybrid Service Manual
Removing the Front I/O Panel
Installing the Front I/O Panel
CAUTION:
Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
Removing the Front I/O Panel
1. Follow the procedures in
Before You
2. Remove the computer cover (see
3. Remove the drive cage (see
NOTICE:
Carefully note the routing of each cable before you disconnect it, so that you re-route the cable correctly. An incorrectly routed or a
disconnected cable could lead to computer problems.
4. Disconnect the flex-cable from the system board, then press the two tabs located on the top and gently pull the front panel away from the chassis.
1
front panel
2 bottom tabs (2)
3
top tabs (2)
4 flex-cable
Installing the Front I/O Panel
1. Follow the procedures in
Before You
2. Connect the flex-cable to the system board (TPB_CON1).
3. Align the four tabs with the corresponding slots on the chassis and gently push the front panel until it snaps into place.
Begin.
Removing the Computer
Cover).
Removing the Drive
Cage).
Begin.
Advertisement
Table of Contents
