Dell Studio Hybrid Service Manual page 37

CAUTION: Before you begin any of the procedures in this section, follow the safety instructions located in the Product Information Guide.
1. Follow the procedure in Before You
NOTE: The computer must be disconnected from the electrical outlet to clear the CMOS setting.
2. Remove the computer cover (see
3. Remove the drive cage (see
4. Locate the 3-pin CMOS jumper on the system board (see
5. Move the 2-pin jumper plug from pins 3 and 2 to pins 1 and 2.
6. Wait for five seconds for the CMOS to clear.
7. Move the 2-pin jumper plug back to pins 3 and 2.
NOTE: The computer will not turn on if you do not replace the 2-pin jumper on pins 3 and 2.
8. Replace the drive cage (see
9. Replace the computer cover (see
10. Turn on the computer.
11. The message CMOS settings wrong appears on the screen. Restart the computer.
12. The message CMOS checksum error.Press F2 to run setup.Press F1 to load default values and continue appears on the screen.
13. Press <F1> to load default values and continue.
Back to Contents Page
Begin.
Replacing the Computer Cover).
Removing the Drive Cage).
System Board
Installing the Drive Cage).
Installing the Computer Cover).
Components).