Replacing The Battery; Removing The Battery; Installing The Battery - Dell Studio Hybrid Service Manual

Table of Contents

Advertisement

Back to Contents Page
  Replacing the Battery
Dell™ Studio Hybrid Service Manual 
  Removing the Battery
  Installing the Battery
 
CAUTION:
Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
A coin-cell battery maintains computer configuration, date, and time information.
If you have to repeatedly reset time and date information after turning on the computer, replace the battery.
 
CAUTION:
A new battery can explode if it is installed incorrectly. Replace the battery only with the same or equivalent type recommended by the
manufacturer. Discard used batteries according to the manufacturer's instructions.
 Removing the Battery
 
1. Make a note of the settings in system setup (see
 
2. Follow the procedures in
Before You
 
3. Remove the computer cover (see
 
4. Remove the drive cage (see
 
5. The battery is stuck to the side of the chassis. Remove the battery by carefully pulling it away.
 
6. Disconnect the battery cable from the connector(BATCON1) on the system board.
NOTICE:
Carefully note the routing of each cable before you disconnect it, so that you re-route the cable correctly. An incorrectly routed or a
disconnected cable could lead to computer problems.
 Installing the Battery
 
1. Remove the adhesive cover on the battery.
 
2. Stick the battery on the side of the chassis.
 
3. Route the cable through the hook located just above the connector (BATCON1).
 
4. Connect the battery cable to the connector (BATCON1) on the system board.
 
5. Replace the drive cage (see
 
6. Replace the computer cover (see
 
7. Enter system setup (see
System
 
System
Setup) so that you can restore the correct settings after the new battery has been installed.
Begin.
Removing the Computer
Cover).
Removing the Drive
Cage).
Installing the Drive
Cage).
Installing the Computer
Cover).
Setup) and restore the settings you recorded in
step
1.

Advertisement

Table of Contents
loading

Table of Contents