Preparing Your Work Space - Gateway M675 Service Manual

Preparing your work space

Before performing maintenance on the notebook, make sure that your work space and
the notebook are correctly prepared.
■ Wear a grounding (ESD) wrist strap, and use a grounded or dissipative work mat.
■ Use a stable and strong table, and make sure that the table top is large enough to
hold each component as you remove it.
■
Use bright lighting to make part identification easier.
■ Keep your work surface free from clutter and dust that may damage components.
■ Use a magnetized screwdriver for removing screws.
■ When removing components that are attached to the notebook by a cable, unplug
the cable before removing the screws, when possible, to avoid damaging the cable.
■
As you remove components and screws, lay them toward the rear of your work surface
(behind the notebook) or far enough to the side that your arms do not accidentally
brush them onto the floor.
■ To help keep track of screws, try the following:
Place each component's screws in their own section of a parts sorter.
■
Place each component's screws next to the component on your work surface.
■
Print the first page of each task, then place the page toward the rear of your work
■
surface. As you remove screws, place the screws in their respective boxes on the
page. Where screw measurements are shown, the first number indicates screw head
width, and the second number indicates screw length.
When you place flat-headed screws on your work surface, stand them on their
■
heads to prevent the screws from rolling off the table.
4
www.gateway.com