Mandatory Rpm Programming - Avital AviStart 6000 Installation Manual

Mandatory RPM Programming

In order to remote start the vehicle engine and prevent over-grinding of the
starter motor, the engine RPM must be programmed into the system memory.
1. Start the engine with the ignition key. Let the engine warm up until it
reaches a normal idle RPM (typically 700-900 RPM).
2. Turn the ignition key "OFF.".
3. Start the engine with the ignition key.
4. Within 10 seconds of starting the vehicle, begin flicking the valet switch
on then off 14 times (counting the siren chirps).
NOTE: Stop on the 14th chirp. See the "Programming Table for System
Features" on page 25.
5. Press and hold the remote START button.
6. The parking lights will flash two times to confirm the RPMs have been
memorized.
7. Release the START button.
20
AviStart 6000 Installation Manual