Installation Procedures; Control Unit; Rangemaster™ Super Heterodyne Receiver Module; Wireloom - Avital AviStart 6000 Installation Manual

Remote engine starter & vehicle security system

Hide thumbs Also See for AviStart 6000:

Table of Contents

1. Select a location under the dash that will allow you to use the tie wraps to

securely fasten the control unit.

2. Mount the control unit as high as possible to ensure maximum security.

3. Do not mount the control unit near moving parts.

4. Avoid areas that are in the direct path of air blowing from the vents.

5. Route wires from this point, leaving slack for ease of service.

RangeMaster™ Super Heterodyne Receiver Module

1. Plug the receiver module WHITE connector into the control unit WHITE

plug.

2. Use tie wraps to fasten the receiver module as far from the control unit as

possible.

3. Route the antenna cable up through the driver side windshield pillar,

behind the headliner and behind the rear view mirror.

4. Use the small mounting tabs to attach the antenna to the windshield,

behind the rear view mirror approximately 2" below the top of the

windshield. Attach vertically for maximum performance.

1. Plug the wirelooms securely into the control unit and satellite relay

module.

2. Route wires from the control module and satellite relay module directly to

each connection point.

3. Separate the small and large RED, RED/WHITE, BLACK, TAN, VIOLET

and WHITE/GREEN wires.

4. Sleeve these wires with vinyl tubing or electrical tape and route them

through an existing rubber grommet into the engine compartment.

5. If an existing grommet is not available, drill a hole and install a snap

grommet.

AviStart 6000 Installation Manual

Installation Procedures

Table of Contents