Announcing A Call By Intercom - Fujitsu SRS-1050 User Manual

Chapter 3
To program the first number, go to step 2. To program the second or third number, press NEXT (softkey 2) to
display (2) or (3) on the screen.
2. Press ENTER.
The call announce intercom selection screen appears:
1:ONE WAY 2:TWO WAY
3:TURN OFF (SELECT 1-3)
3. To enable the intercom feature, dial 1 or 2 and press ENTER. A screen appears showing your choice and
prompting for an authorized Directory Number (see step 4).
To disable the intercom feature, dial 3 and press ENTER. When the screen displays the message INTERCOM
TURNED OFF, press REG (softkey 4) to return to normal operation.
TWO WAY SELECTED
ENTER TELEPHONE NUMBER
4. Dial a telephone number of up to ten digits (including wild cards) and press ENTER (softkey 1).
If the call screener has Directory Numbers identified by three-, four-, or five-digit extension numbers, you can dial
either the extension number only or the full number. You can also dial an asterisk as a wild card character. See the
section introduction for a complete explanation of these choices.
When you press ENTER, a screen appears announcing ONE (or TWO) WAY TURNED ON and showing the
number you entered.
TWO WAY TURNED ON
985*3112
5. Press REG (softkey 4) to return to normal operations.

Announcing a Call by Intercom

This procedure describes a typical sequence for announcing a call by intercom. The procedure addresses the call
screener since the call recipient has little to do. The only action possibly required of the recipient is described in
step 5.
The procedure also assumes that both the screener and the call recipient have an SRS-1050 digital set, although
only the recipient must have one. If the call screener has some other telephone set, the exact procedure may be
different.
This procedure is by no means the only way that you can use call announce intercom, but it is the simplest and
fastest..
To announce a call by intercom, follow these steps:
1. Press the Directory Number designated for call announce intercom.
The intercom Directory Number indicator lights normally.
2. Dial the extension of the call recipient.
( SRS -1050 Local Features
Page 3-39