Fujitsu SRS-1050 User Manual page 111

SRS -1050 Installation (
To label the buttons on the set,
you must first remove the
plastic cover over the front
panel. Insert a pointed object
into the semi-circular notch at
the bottom middle of the plastic
cover and lift the cover upward.
Below the cover is a template.
Write button labels on this
template to show the directory
numbers or features assigned
to each button. Then lay the
template back on the front
panel. Reinsert the plastic
cover.
Fujitsu has developed a
DOS/Windows and a
Macintosh application file using
Microsoft EXCEL 4.0 and Excel
5.0 to assist you in printing the
templates. These files are
available for no charge via our
World Wide Web site at
http://www.fnc.fujitsu.com.
For use with the printing
application, Fujitsu has
included a laser printer
compatible paper template in
the SRS-1050 User's Guide.
As an alternative, you may
print, type, or write in the
needed designation on the
template. Additional templates
may be purchased from your
distributor or from Fujitsu.
Page A-6
Do not remove the
perforated display window
from the template until after
printing.
All other loose materials
must be removed before
placing the template in the
laser printer. Failure to
remove loose materials may
result in a paper jam in the
printer. Templates are fed
via the manual feed tray.
Please address questions
about the program to FNC
TAC, at 1-800-228-ISDN.
Fujitsu Terminal Equipment
Termination Resistors (TR)
Fujitsu ISDN phones have a
Terminating Resistor (TR)
switch on the back of the set.
The options are ON and OFF.
NOTE: The default setting for
the Fujitsu TR switch is the
OFF position.
Fujitsu TR's are equivalent to
100 Ohms in the ON position.
Refer to the following
discussions for TR setting
recommendations.
NT1 Settings
Termination
Appendix A