Fujitsu SRS-1050 User Manual page 56

SRS -1050 Local Features (
12:55PM
Key Menu
UNA DATA
Some of the data entry screens in
menu mode procedures have
built-in timers. If you do not enter
information within 15 seconds,
the display reverts back to the
menu for selecting the feature you
were using. You must reselect the
feature and start over.
If for any reason you become
confused while working in menu
mode, you can always press REG
(softkey 4) to return to the menus
and start over.
Selecting a Menu Option
You can display and choose
among the twelve menu options
at any time, as follows:
1. Press REG (softkey 4) to display
the menu options. The Screen
looks like this:
1:ONE-TOUCH 2:CALENDAR
3:INITIAL
To see the next menu screen,
press NEXT (softkey 2):
Page 3-2
TUE MAY 5
Key Menu
CLEAR REG
(SELECT 1-12)
4:UNA 5:H-FREE
6:HAND/HEAD (SELECT 1-12)
Press NEXT again to see the third
menu:
7:RINGER 8:SPID/TEI
9:MSG-LOG (SELECT 1-12)
Press NEXT again to see the
fourth menu.
10:U-CODE
12:MIC-OFF
Press NEXT repeatedly to cycle
through these menus.
2. To select the option you want,
press the appropriate key(s) on
the numeric keypad to dial 1 to
12 (do not press one of the four
buttons under the screen), and
then press ENTER (softkey 1).
If you notice a mistake after
pressing ENTER and want to
cancel the keypad entry, press
asterisk (*). To clear an entry
before pressing ENTER, press
CLEAR (softkey 3).
3. To exit menu mode, press REG
(softkey 4). If you forget to exit,
menu mode is automatically
canceled after four minutes, or
whenever you pick up the
handset or press SPEAKER.
Chapter 3
11:I-COM
(SELECT 1-12)