Placing Handset Calls - Fujitsu SRS-1050 User Manual

Chapter 2
To make the best of handsfree
mode, you should be sure that the
MIC-OFF key feature is active on
the button at the upper-right of
the array. This feature is set
active by default when you
receive your SRS-1050. If for
some reason this feature is not
active, see the section Activating
the MIC-OFF Key in Chapter 3 for
the activation procedure.
(See also "Handsfree, Handset,
and Headset Modes", in Chapter
3, "Local Features".)
Switching between Handset
and Handsfree Modes
If you are using the handset
and want to use handsfree
mode
1. Press SPEAKER and then
replace the handset in its cradle.
You now hear the other parties
on the call through the speaker.
2. If the MIC-OFF LED is red, the
microphone has been turned off.
Press MIC-OFF to turn it back
on (the LED goes dark). The
microphone now picks up your
voice.
3. You can turn off the microphone
by pressing MIC-OFF, allowing
you to hold a private
conversation with others in the
room. Pressing MIC-OFF again
turns the microphone back on.
( SRS -1050 Voice Features
Note: If the MIC-OFF feature is
not active, the microphone is
always on.
If you are using handsfree
mode and want to use the
handset
Pick up the handset. Your call
continues without interruption.
The handsfree speaker and
microphone are turned off. (You
cannot turn off the microphone in
the handset.)

Placing Handset Calls

If you are not talking on
another call
1. Pick up the handset. This
should automatically give you a
dial tone, if not press an idle Call
Appearance (CA).
If this connects you with a
ringing call, follow the
procedure described in the
next section.
Page 2-3