Entering A Service Profile Identifier - Fujitsu SRS-1050 User Manual

SRS -1050 Local Features (
To announce a call by intercom,
follow these steps:
1. Press the Directory Number
designated for Call Announce
Intercom. The intercom
Directory Number indicator
lights normally.
2. Dial the extension of the call
recipient.
The recipient's SRS-1050
immediately answers the call,
sounds an alert tone, and
activates the intercom feature.
3. Talk to the recipient.
If the recipient is set up for one-
way intercom, pause a few
seconds to give the recipient time
to press the MIC-OFF button and
respond. With two-way intercom,
the recipient can respond
immediately just by speaking.
Note: To transfer the call at the
same time you announce it,
use the conference call
transfer procedure.
Page 3-26
ENTERING A SERVICE
PROFILE IDENTIFIER
You need to perform this
procedure only if you are
connected to a multipoint
configuration. Usually, though,
the SPID is entered at the time of
installation and no action is
required of you. If you have
questions, ask your System
Administrator.
Warning: Once the SPID
number is entered, don't
change it unless your system
administrator tells you to.
Digital sets in a multipoint
configuration won't work
without the correct SPID
number. If the SPID number is
wrong, you'll hear a broken
tone ("stutter dial tone")
before the normal dial tone.
Enter the correct SPID number
and you'll get the normal dial
tone.
If you need to enter a service
profile identifier, follow these
steps:
1. Press REG (softkey 4), 8, ENTER
(softkey 1). The message
ENTER SPID appears, with the
current SPID number (if any)
shown below it:
ENTER SPID
ID=0000000000
Chapter 3