Troubleshooting; Alarms - Sony PDW-HR1 Operation Manual

Troubleshooting

Alarms

An alarm (warning message) appears in the time data
display area when an operation is attempted which is
inappropriate for the settings on this unit or the state of the
disc. Both the alarm message and the action to take to
resolve the problem appear in the video monitor screen and
on the screen of the external video monitor connected to
the unit.
When the unit is powered on
Alarm message in time
data display area
ADJ. Mode!
MENU Ver.UP
ILL. SETUP!
Exchg batt!
Update Err!
170
Troubleshooting
Alarm message in video monitor screen
THE UNIT IS IN ADJUSTMENT MODE.
CHECK THE SWITCHES OF S2200 ON THE
HPR-31 BOARD AND S500 ON THE NET-5
BOARD.
THE SETUP MENU SOFTWARE HAS BEEN
UPGRADED.
SET THE SETUP MENU ITEMS TO THE
DESIRED SETTINGS.
INVALID SETTINGS SELECTED IN SETUP
MENU.
SET ITEMS IN THE SETUP MENU TO THE
APPROPRIATE VALUES. CONTACT SERVICE
IF THIS ALARM APPEARS AGAIN AFTER
ABOVE PROCEDURE.
BATTERY NEEDS REPLACING. PLEASE
CONTACT SERVICE.
RUN SOFTWARE UPDATE PROGRAM.
Example alarm in time data display area
ALARM
REMOTE MODE IS SELECTED.
SET REMOTE/LOCAL/NETWORK
SWITCH TO LOCAL.
Example alarm in video monitor screen
When an alarm is displayed, remove the alarm cause by
following the action to take. If the alarm display does not
disappear, contact a Sony service representative.
Please note that there are some alarms which do not appear
depending on the setting of setup menu item 016 ALARM
DISPLAY (see page 136).
See "Setup Menu" (page 133) for more information about
setup menu operations.
Description/action
This appears when the unit is in adjustment
mode.
Contact a Sony service representative.
Reset the settings in the setup menu (see
page 139).
Reset the settings in the setup menu (see
page 139). If the same message appears after
you reset the settings, contact a Sony service
representative.
The NVRAM battery is exhausted. Contact a
Sony service representative.
The software version is not properly updated.
Update the software version again. If the same
message appears after you update the software
version, contact a Sony service representative.