Removing Dimms - Fujitsu SPARC Enterprise T2000 Service Manual

5.2.3

Removing DIMMs

Note – Not all DIMMs detected as faulty and offlined by POST must be replaced. In
service (maximum) mode, POST detects memory devices with errors that might be
corrected with Solaris PSH. See
on page
Caution – This procedure requires that you handle components that are sensitive to
static discharges that can cause the component to fail. To avoid this problem, ensure
that you follow antistatic practices as described in
Electrostatic Discharge Prevention Measures" on page
1. Perform the procedures described in
Replacement" on page
2. Locate the DIMMs (
Use
FIGURE 5-8
Note – For memory configuration information see
Guidelines" on page
5-12 SPARC Enterprise T2000 Server Service Manual • April 2007
3-36.
5-1.
FIGURE 5-8
and to identify the DIMMs you want to remove.
TABLE 5-1
6-4.
Section 3.4.5, "Correctable Errors Detected by POST"
Section 5.1.6, "Performing
Section 5.1, "Common Procedures for Parts
) that you want to replace.
Section 6.2.1, "Memory
5-6.