Exercising The System With Sunvts; Checking Whether Sunvts Software Is Installed - Fujitsu SPARC Enterprise T2000 Service Manual

2. After receiving confirmation that the enablecomponent command is complete,
reset the server for so that the ASR command takes effect.
sc> reset
3.8

Exercising the System With SunVTS

Sometimes a server exhibits a problem that cannot be isolated definitively to a
particular hardware or software component. In such cases, it might be useful to run
a diagnostic tool that stresses the system by continuously running a comprehensive
battery of tests. Sun provides the SunVTS software for this purpose.
This chapter describes the tasks necessary to use SunVTS software to exercise your
server:
Section 3.8.1, "Checking Whether SunVTS Software Is Installed" on page 3-49
■
Section 3.8.2, "Exercising the System Using SunVTS Software" on page 3-50
■
3.8.1

Checking Whether SunVTS Software Is Installed

This procedure assumes that the Solaris OS is running on the server, and that you
have access to the Solaris command line.
1. Check for the presence of SunVTS packages using the pkginfo command.
% pkginfo -l SUNWvts SUNWvtsr SUNWvtsts SUNWvtsmn
The following table lists SunVTS packages:
Package
SUNWvts
SUNWvtsr
SUNWvtsts
SUNWvtsmn
If SunVTS software is installed, information about the packages is displayed.
■
Description
SunVTS framework
SunVTS framework (root)
SunVTS for tests
SunVTS man pages
Chapter 3 Server Diagnostics 3-49