6. Remove the five screws that secure the SAS disk backplane to the chassis
(
FIGURE 5-25
FIGURE 5-25
7. Remove the SAS disk backplane from the chassis and place it on an antistatic mat.
5.2.20
Replacing the SAS Disk Backplane
1. Unpackage the replacement SAS disk backplane and place it on an antistatic mat.
2. Place the SAS disk backplane on the two ledges on the bottom of the drive cage
assembly, with the power connector facing down toward the bottom of the chassis.
The ledges hold the backplane in place temporarily.
5-38
SPARC Enterprise T2000 Server Service Manual • April 2007
).
SAS disk
backplane
Power cable
connector
le plug
Removing the SAS Disk Backplane