Managing Components With Automatic System Recovery Commands; Table 3-11 Asr Commands - Fujitsu SPARC Enterprise T2000 Service Manual

2. Issue the following command:
# more /var/adm/messages
3. If you want to view all logged messages, issue the following command:
# more /var/adm/messages*
3.7 Managing Components With Automatic
System Recovery Commands
The Automatic System Recovery (ASR) feature enables the server to automatically
configure failed components out of operation until they can be replaced. In the
server, the following components are managed by the ASR feature:
UltraSPARC T1 processor strands
■
Memory DIMMS
■
I/O bus
■
The database that contains the list of disabled components is called the ASR blacklist
(asr-db).
In most cases, POST automatically disables a faulty component. After the cause of
the fault is repaired (FRU replacement, loose connector reseated, and so on), you
must remove the component from the ASR blacklist.
The ASR commands (
components from the ASR blacklist. You run these commands from the ALOM CMT
sc> prompt.
TABLE 3-11
Command
showcomponent
enablecomponent asrkey
disablecomponent asrkey
clearasrdb
* The showcomponent command might not report all blacklisted DIMMS.
3-46 SPARC Enterprise T2000 Server Service Manual • April 2007
) enable you to view, and manually add or remove
TABLE 3-11
ASR Commands
*
Description
Displays system components and their current state.
Removes a component from the asr-db blacklist,
where asrkey is the component to enable.
Adds a component to the asr-db blacklist, where
asrkey is the component to disable.
Removes all entries from the asr-db blacklist.