Removing The Front Bezel And Top Front Cover; Figure 5-3 Top Cover And Release Button - Fujitsu SPARC Enterprise T2000 Service Manual

1. Press the top cover release button (
Fan cover
Fan
cover latch
FIGURE 5-3
2. While pressing the top cover release button, slide the cover toward the rear of the
server about half of an inch.
3. Lift the cover off the chassis.
5.1.8

Removing the Front Bezel and Top Front Cover

The following field-replaceable units (FRUs) require the removal of the top front
cover and front bezel:
Motherboard
■
SAS disk backplane
■
LED board
■
Front I/O board
■
Fan power board
■
DVD
■
1. Remove the top cover as described in
page
2. Lift the fan cover latch (
3. Loosen the captive screw (near the farthest right fan) that secures the bezel to the
chassis (
Top cover
Top Cover and Release Button
5-6.
FIGURE 5-3
).
FIGURE 5-4
).
FIGURE 5-3
Top cover release button
Top front cover
Section 5.1.7, "Removing the Top Cover" on
) and open the fan cover.
Chapter 5 Replacing Cold-Swappable FRUs 5-7