Replacing Dimms; Removing Dimms - Fujitsu SPARC Enterprise T1000 Service Manual

5.6

Replacing DIMMs

5.6.1

Removing DIMMs

Note – Not all DIMMs detected as faulty and offlined by POST must be replaced. In
service (maximum) mode, POST detects memory devices with errors that might be
corrected with Solaris PSH. See
on page
Caution – This procedure requires that you handle components that are sensitive to
static discharges that can cause the component to fail. To avoid this problem, follow
the antistatic practices as described in
1. Perform the procedures described in
2. Locate the DIMM that you want to remove.
Use
FIGURE 5-14
3-35.
and
TABLE 5-1
Section 3.4.5, "Correctable Errors Detected by POST"
Chapter 4.
Chapter 4.
to identify the DIMM that you want to remove.
Chapter 5 Replacing Field-Replaceable Units 5-19