Mounting/Removing The Basic Unit - Fujitsu PRIMERGY BX600 S3 Operating Manual

Installing the System in the Rack
4.3.2

Mounting/Removing the Basic Unit

V
CAUTION!
For safety reasons, at least two people are required to mount or
remove the PRIMERGY BX600 S3 basic unit because of its weight
and size.
Please note the relevant safety instructions in
in the Rack" on page
Before lifting the basic unit into the rack, remove server blades, fan units
and power supplies from the basic unit to reduce weight.
Figure 8: Mounting the basic unit
Ê Note the slot assignment of the server blades so that you can insert them
correctly again once you have lifted the basic unit into the rack.
Ê Remove server blades, fan units and power supplies from the system unit to
reduce weight (for assembly instructions see
to the Basic Unit" on page
page 133 and
Ê Lift the basic unit onto the two carrier rails.
Ê Slide the basic unit into the rack (1).
Ê Secure the basic unit in the rack using the four knurled screws (2).
40
27.
74, section "Replacing a Power Supply Unit" on
section "Replacing the Fan Unit" on page
Operating Manual
Installing the Hardware
section "Notes on Installing
section "Adding a Server Blade
141).
BX600 S3