Fujitsu PRIMERGY BX600 S3 Operating Manual page 150

Troubleshooting and Tips
Added drive is identified as defective
The RAID controller is not configured for the drive. The drive was probably
installed while the system was switched off.
Ê You can configure the RAID controller for the drive after its installation using
the relevant utility. For how to do this, see the documentation for the RAID
controller (on the ServerBooks CD under the heading "Controllers").
or
Ê Remove the drive and reinstall it with the system switched on.
If the drive is still identified as defective, you will need to replace it.
150 Operating Manual
BX600 S3