Chain-Playing Disks In A Group - Yamaha DGT7A Advanced Operation Manual

4
Use [<] and [>] to move the
cursor to a disk number, then use
the [–/NO] and [+/YES] buttons to
select or unselect it.
• The position of the cursor is indicated by
the flashing disk number.
• Pressing both [+/YES] and [–/NO]
simultaneously selects all disks.
• "x" indicates disks that you included in
the group but that contain no songs or are
unformatted.
• "_" indicates disks that you did not
include in the group.
5
Press [ENTER].
The group is set, and the display returns to
the setup menu.
6
With the cursor at the End option,
press [ENTER] to restart the
Control Unit.
This is the same as turning off the Control
Unit and then turning it back on.
The standard disk title display appears.
10
Flashes
Chain-Playing Disks in
a Group
One of the advantages of the group feature is its
ability to automatically play back disks in a group
consecutively without the need to make settings
after each Memory Disk has finished playing.
This is called Memory Disk Chain Play. Chain
Play can also be set to start from any disk within
the group.
Note: Chain Play is not valid for floppy disks and
CDs.
Note: Prolonged playing may cause your piano to
overheat. Insert sufficient breaks between
continuous song playback.
1
Register or select a group.
See "Registering a Group" on page 9.
2
Press the [SELECT] buttons and
specify the disk from which you
want to begin Memory Disk Chain
Play.
The disk you select flashes.
The group number you chose in step 1, and
its contents, are shown on the bottom line
of the display. If [- - - -] is shown instead of
a group number, you have not chosen a
group correctly.
• "x" indicates disks that are included in the
group but that contain no songs or are
unformatted.
• "_" indicates disks that are not included in
the group.
You can set playback to start from any disk
in the group that contain songs.
Flashes