Yamaha DGT7A Advanced Operation Manual page 30

2
Use [<] and [>] to select a
parameter: click, tempo, time
signature, volume, or pedal count.
3
Use the [–/NO] and [+/YES]
buttons to set the selected
parameter.
4
Press [REC] to engage the Record
Standby mode.
With each beat of the metronome, a short
click is produced. This click can be turned
on and off as desired. Also, the Volume
LED indicators flash. On the first beat of
each measure, all the indicators flash and
on the remaining beats, the left half and
right half of the indicators flash alternately.
1st beat
2nd beat
3rd beat
-10 -8 -6 -4 -2 0
-10 -8 -6 -4 -2 0
-10 -8 -6 -4 -2 0
5
Press [PLAY/PAUSE].
The metronome starts and recording begins
immediately.
The LED volume indicators flash to show
the beat and the beat indicator starts
counting (001 – 1). The display will cycle
as shown below in the first measure.
The display will return to the normal
recording display as soon as you start
playing.
If recording is paused, the metronome will
pause, and begin again when recording is
resumed.
25