Kyocera TASKalfa 3051ci Technical Reference Manual page 211

Table 7.27. FRPO G0 Command Options
Bit Position Bit Value Logic Value Description
4 0 0
16 1
5 0 0
32 1
Plot Coordinates (bit 0)
This bit defines one of two plotting coordinate modes. (See Figure 7. 28. on page 99.)
0 = Mode A
1 = Mode B
In mode A, the origin (0, 0) starts at bottom left. In mode B, the origin starts at the center
of the page.
Response to SP Instruction (bit 1)
This bit defines the printing system response to the SP (Select Pen) instruction.
0 = Printing System feeds out a page when it receives a SP; or SP 0; instruction.
1 = Printing System returns the pen to the stall from which it came, in other words, it
prints nothing when it receives a SP; or SP 0; instruction.
Figure 7. 28. Plot Coordinates
Mode A (G0, 0;)
Mode B (G0, 1;)
Automatic Plot Coordinate Mode (bit 2)
0 = Printing System changes the plot coordinate from mode A to mode B when it
receives a IP (Input P1 and P2) instruction using the negative parameter value.
When the IN
(INitialize) instruction is later given, the printing system reverts to mode A.
HP 7550A Emulation [KC-GL] (Mode 8)
Landscape page orientation
Page orientation to FRPO C1
Default cursor at top left
Default cursor at bottom left
7-99