Kyocera TASKalfa 3051ci Technical Reference Manual page 111

Table 6.2. Interface-independent Parameters (Sheet 7 of 8)
Environment Parameter Value
PCL paper source X9
Automatic continue for Y0
'Press GO'
Automatic continue Y1
timer
Quick fuser heater Y2
Error message for Y3
device error
Duplex operation for Y4
specified paper type
(Prepunched, Preprinted
and Letterhead)
25: Custom5
26: Custom6
27: Custom7
28: Custom8
0: Performs paper selection depending on
media type.
1: Performs paper selection depending on
paper sources.
2: Performs paper selection which is
compatible with HP-LJ8000.
3: Combination of value 1 and 2.
8: Performs paper selection in driver priority
mode.
9: Combination of value 1 and 8.
10: Combination of value 2 and 8.
11: Combination of value 1, 2 and 8.
0: Off
1: On
number from 000 to 495 in increments of 5
seconds
0: On
1: Off
0: Does not display an error message and pause
the job when the device error occurs.
1: Displays an error message when duplex
printing is not executed because of a possible
limitation.
2: Displays an error message and pause the job
when running out of staples.
3: Combination of value 1 and 2.
4: Displays an error message and pause the job
when the waste punch box is full.
5: Combination of value 1 and 4.
6: Combination of value 2 and 4.
7: Combination of value 1, 2 and 4.
8: Displays an error message and pause the job
when the maximum number of stapling is
exceeded.
9: Combination of value 1 and 8.
10: Combination of value 2 and 8.
11: Combination of value 1, 2 and 8.
12: Combination of value 4 and 8.
13: Combination of value 1, 4 and 8.
14: Combination of value 2, 4 and 8.
15: Combination of value 1, 2, 4 and 8.
16: Displays an error message when stapling,
puching, offset or rotate collate is not
executed because of a possible limitation
except 2, 4 and 8.
17: Combination of value 1 and 16.
18: Combination of value 2 and 16.
19: Combination of value 1, 2 and 16.
20: Combination of value 4 and 16.
21: Combination of value 1, 4 and 16.
22: Combination of value 2, 4 and 16.
23: Combination of value 1, 2, 4 and 16.
24: Combination of value 8 and 16.
25: Combination of value 1, 8 and 16.
26: Combination of value 2, 8 and 16.
27: Combination of value 1, 2, 8 and 16.
28: Combination of value 4, 8 and 16.
29: Combination of value 1, 4, 8 and 16.
30: Combination of value 2, 4, 8 and 16.
31: Combination of value 1, 2, 4, 8 and 16.
0: Leaves the job as is when the job which the
specified paper type is specified in simplex
mode.
1: Adds blank pages and prints the job in
duplex mode when the job which the
specified paper type is specified in simplex
mode.
Factory setting
8 (model supporting
driver priority mode)
or 0 (other)
0
6
0 or 1
0
0
6-11