Resuming After An Area Over Warning - Fujitsu DL3750+/3850+ User Manual

User's Manual

Resuming after an Area Over warning

The printer senses the left and right edges of paper and stores their positions
when the paper is loaded. If your software will print data past either edge, the
printer ignores that data but does not stop printing. Rather, the AREA OVER
indicator lights to call your attention to the loss of data.
The AREA OVER indicator functions when AREACNT (area control) is set
to ENABLE in setup mode. See Chapter 5 for information on setting
AREACNT. The factory default is not to sense the edges. If paper is dark-
colored or preprinted, the printer may not be able to sense the edges correctly.
In this case, disable the sensor.
To resume printing when the AREA OVER indicator is on:
1. Stop your software and press the ONLINE button to place the printer
offline.
2. Adjust the horizontal position of the paper or change the margin
settings in the printer setup menu or your software.
3. Press the ONLINE button to place the printer online. Restart the
software from the page that includes the lost data.
PRINTING
PRINTING
4-7