Fujitsu DL3750+/3850+ User Manual page 83

Type
Select
Sub Function
Self Diagnostic
Function
<EMULATE> DPL24C+
<FONT>
COUR 10 PRSTG12 COMPRSD
COUR-I N.SAN-N N.SAN-B
<QUALITY> LETTER
User's Manual
Table 5.1 Setup Mode Functions (Cont.)
Function
DEFAULT Resets factory defaults in MENU1 and MENU2.
LIST Prints a list of all currently selected options.
SELF-TST Runs the self-test.
HEX-DUMP Prints hex dumps.
V-ALMNT Checks and corrects vertical print alignment.
To select a function from the <<FUNCTION>> menu:
1. Repeatedly press the LOAD button or the LF/FF button to position the
red cursor on the plastic print guide under the function you require.
The LOAD button moves the cursor to the next option and the LF/FF
button moves the cursor to the previous option.
2. Press the TEAR OFF button or the MENU button to select the
function. If the function has items and options, the printer prints the
first item and its options. The MENU1, MENU2, HARDWRE,
ADJUST, and CONFIG functions contain items that have selectable
options. The other functions have neither items nor options.
The first three MENU1 items and their options are shown below.
Items are enclosed in single brackets < >.
XL24E ESC/P2
BOLDFCE PICA 10 CORRESP
N.SAN-I TIMLS-N TIMLS-B
REPORT DRAFT HI-DRAFT
USING SETUP MODE
Purpose
OCR-B OCR-A COUR-N
TIMLS-I DOWNLD0 DOWNLD1
COUR-B
5-5