Procedure - Fujitsu DL3750+/3850+ User Manual

<<FUNCTION>>
SAVE&END MENU1
V-ALMNT
<CNT-ORG>
1/6IN 1.8/6IN
10/6IN 11/6IN ....
User's Manual

Procedure

Before adjusting a print position, you should carefully measure the amount
of adjustment required for any paper that demands precise print registration.
To adjust a print position, make sure that continuous forms paper is loaded.
The following example shows how to adjust the top-of-form setting for
continuous forms.
1. Enter setup mode.
Press the TEAR OFF button and the ONLINE button simultaneously
until the printer beeps. Wait for the printer to stop printing and
check that the following <<FUNCTION>> menu is printed:
MENU2 HARDWRE ADJUST
2. Select the ADJUST function.
Repeatedly press the LOAD button or the LF/FF button to position
the red cursor under ADJUST. Press the MENU button or the TEAR
OFF button to select the ADJUST function and print the following
<CNT-ORG> options:
2/6IN 3/6IN 4/6IN
3. Select an option from 1/6IN to 66/6IN.
Press the LOAD button or the LF/FF button to move the cursor to the
required option. Press the MENU button to select the option and
print the <CNTFINE> item. If necessary, fine-tune the top-of-form
position now. Otherwise, go to step 4.
4. Exit the ADJUST function.
Press the ONLINE button to exit the ADJUST function and reprint
the <<FUNCTION>> menu.
CONFIG DEFAULT LIST
5/6IN 6/6IN 7/6IN
USING SETUP MODE
SELF-TST HEX-DUMP
8/6IN 9/6IN
5-39