Using The Diagnostic Functions - Fujitsu DL3750+/3850+ User Manual

USING SETUP MODE
<<FUNCTION>>
SAVE&END MENU1
V-ALMNT
USING THE DIAGNOSTIC
FUNCTIONS
5-50
1. Enter setup mode.
Press the TEAR OFF button and the ONLINE button simultaneously
until the printer beeps. Wait for the printer to stop printing and
check that the following <<FUNCTION>> menu is printed:
MENU2 HARDWRE ADJUST
2. Select the DEFAULT function.
Repeatedly press the LOAD button or the LF/FF button to position
the red cursor under DEFAULT. Press the TEAR OFF button or the
MENU button to select the DEFAULT function. The printer reprints
the <<FUNCTION>> menu. The default values in MENU1 and
MENU2 are now reset.
3. Do either of the following:
• Select new options for MENU1 or MENU2.
• Exit setup mode, saving the factory defaults.
See the section Changing MENU1 and MENU2 Options. To exit
setup mode and save the new defaults, make sure that the red cursor
is positioned under SAVE & END, then press the TEAR OFF button
or the MENU button.
This section describes how to use the following diagnostic functions:
• SELF-TST
• HEX-DUMP
• V-ALMNT
These functions are used for checking print quality and diagnosing printer
problems. HEX-DUMP also provides useful information for programmers.
CONFIG DEFAULT LIST SELF-TST HEX-DUMP
User's Manual