Procedure - Fujitsu DL3750+/3850+ User Manual

USING SETUP MODE
<<FUNCTION>>
SAVE&END MENU1
V-ALMNT
<PPR-OUT> CNTONLY
5-34

Procedure

To change the printer's hardware options, make sure that continuous forms
are loaded and then proceed as follows:
1. Enter setup mode.
Press the TEAR OFF button and the ONLINE button simultaneously
until the printer beeps. Wait for the printer to stop printing and
check that the following <<FUNCTION>> menu is printed:
MENU2 HARDWRE ADJUST
2. Select the HARDWRE function.
Repeatedly press the LOAD button or the LF/FF button to position
the red cursor under HARDWRE. Press the MENU button to select
the HARDWRE function and print the first item and its options, as
shown below:
DETECT IGNORE
3. Select an option for the selected item.
Press the LOAD button or the LF/FF button to move the cursor to the
option you require. Press the MENU button to select the option and
print the next item.
NOTE
To print the previous item, press the TEAR OFF button.
4. Repeat step 3 until all required options are changed.
5. Exit the HARDWRE function.
Press the ONLINE button to exit the HARDWRE function and
reprint the <<FUNCTION>> menu.
CONFIG DEFAULT LIST SELF-TST HEX-DUMP
User's Manual