Exiting And Saving; Procedure - Fujitsu DL7400 User Manual

USING SETUP MODE
EXITING AND
SAVING
<< FUNCTION >>
SAVE&END MENU1 MENU2
HEX-DUMP V-ALMNT INITIAL
5-50
To exit setup mode immediately, select the SAVE & END function.
Any settings changed while in setup mode are saved as the new power-
on defaults for the printer. The new defaults remain active until you
change them again.
NOTE
The only way to exit setup mode without saving your changes is to
turn off the printer. When you turn the printer back on, the previous
default settings are used.

Procedure

To exit setup mode and save your changes using SAVE/END, proceed as
follows:
1. Print the <<FUNCTION>> menu.
The <<FUNCTION>> menu should be the last printed line on
the page. If the menu is not printed, press the ONLINE button to
print the menu. The <<FUNCTION>> menu is shown below:
HARDWRE ADJUST CONFIG
2. Select the SAVE/END function.
Make sure that the cursor on the left edge of the aluminum print
guide is positioned under SAVE & END. Press the
the button to select SAVE & END. The printer exits setup
mode and returns online (the ONLINE indicator lights green).
Any changes you made while in setup mode are saved.
GAP-ADJ DEFAULT LIST SELF-TST
button or
User's Manual