Using The Print And Hold Function; Printing A Font Sample List; Printing And Deleting Held Jobs - Dell 3115cn Color Laser Printer User Manual

To print samples of all the fonts currently available for your multifunction printer:
1. Press until >SETUP appears, and then press
2. Press until >Reports appears, and then press
3. Press until either PCL Fonts List or PS Fonts List appears.
Select PCL Fonts List to print a listing of the fonts available to the PCL.
Select PS Fonts List to print a listing of the fonts available to the Adobe PostScript 3
4. Press .
The message PCL Fonts List Printing or PS Fonts List Printing appears and remains on the operator
panel until the page prints. The multifunction printer returns to the standby mode after the font sample list
prints.

Using the Print and Hold Function

When you send a job to the multifunction printer, you can specify in the driver that you want the
multifunction printer to hold the job in memory. When you are ready to print the job, you must go to the
multifunction printer and use the operator panel menus to identify which job in the memory you want to
print. You can use this function to print a confidential job (Secure Print), or verify one copy before printing
additional copies (Proof Print).
NOTE: The multifunction printer holds the job until you delete it by using the operator panel or you
turn off the multifunction printer. The data on memory is cleared when the multifunction printer is
turned off.
NOTE: Print and Hold functions require a minimum of 384 MB available print memory. Also, you need
to configure the RAM disk settings on both the operator panel and the printer driver.
NOTE: Depending on the documents, its job may be too big for the available memory. In this case, an
error occurs.
NOTE: If a document name is not assigned to your print job in the print driver, the job's name will be
identified using the PC's time and date of submission to distinguish it from other jobs you have stored
under your name.

Printing and Deleting Held Jobs

Once held jobs are stored in print memory, you can use the printer operator panel to specify what you want
to do with one or more of the jobs. You can select either Secure Print and Proof Print from
Print". Then, you select your user name from a list. If you select Secure Print, you must type the password
you specified in the driver when you sent the job. See
.
.
"Secure Print" for more information.
™
.
"Stored