Wired Network
Use the Wired Network menu to change printer settings affecting jobs sent to the multifunction printer
through the wired network.
NOTE:
Values marked by an asterisk (*) are the factory default menu settings.
Ethernet
Purpose:
To specify the communication speed and the duplex settings of Ethernet. The change becomes effective after
the multifunction printer is turned off and then on again.
Values:
Detects the Ethernet settings automatically.
Auto*
Uses 10base-T half-duplex.
10 Base Half
Uses 10base-T full-duplex.
10 Base Full
Uses 100base-TX half-duplex.
100 Base Half
Uses 100base-TX full-duplex.
100 Base Full
TCP/IP
Purpose:
To specify the TCP/IP settings for the wired network. The change becomes effective after the multifunction
printer is turned off and then on again.
Values: