Wireless; Wireless Settings - TP-Link TL-WR710N User Manual

3. When you choose the Smart IP (DHCP) mode, the DHCP Server function will be disabled.

7.6 Wireless

Figure 7-6 Wireless menu
There are two submenus under the Wireless menu (shown in Figure 7-6): Wireless Settings and
Wireless Security. Click any of them, and you will be able to configure the corresponding
function.

7.6.1 Wireless Settings

Choose menu "Wireless → Wireless Settings", and then you can configure the basic settings
for the wireless network on this page.
Enable WDS - The AP client can connect to AP with WDS enabled or disabled. If WDS is
enabled, all traffic from wired networks will be forwarded in the format of WDS frames
consisting of four address fields. If WDS is disabled, three address frames are used. If your
AP supports WDS well, please enable this option.
Wireless Name of Root AP - Enter the SSID of AP that you want to access.
MAC Address of Root AP - Enter the MAC address of AP that you want to access.
Region - Select your region from the pull-down list. This field specifies the region where the
wireless function of the Router can be used. It may be illegal to use the wireless function of
the Router in a region other than one of those specified in this field. If your country or region
is not listed, please contact your local government agency for assistance.
TL-WR710N 150Mbps Wireless N Mini Pocket Router
Figure 7-7 Wireless Settings - Client
- 168 -