Gettemp0() Error Codes - Intel E5205 - Cpu Xeon 1.86Ghz Fsb1066Mhz 6M Lga771 Dual Core Tray Datasheet

Dual-core intel xeon processor 5200 series
Hide thumbs Also See for E5205 - Cpu Xeon 1.86Ghz Fsb1066Mhz 6M Lga771 Dual Core Tray:
Table of Contents

Advertisement

Thermal Specifications
6.3.2.3
PECI Fault Handling Requirements
PECI is largely a fault tolerant interface, including noise immunity and error checking
improvements over other comparable industry standard interfaces. The PECI client is
as reliable as the device that it is embedded in, and thus given operating conditions
that fall under the specification, the PECI will always respond to requests and the
protocol itself can be relied upon to detect any transmission failures. There are,
however, certain scenarios where PECI is known to be unresponsive.
Prior to a power on RESET# and during RESET# assertion, PECI is not guaranteed to
provide reliable thermal data. System designs should implement a default power-on
condition that ensures proper processor operation during the time frame when reliable
data is not available via PECI.
To protect platforms from potential operational or safety issues due to an abnormal
condition on PECI, the Host controller should take action to protect the system from
possible damage. It is recommended that the PECI host controller take appropriate
action to protect the client processor device if valid temperature readings have not
been obtained in response to three consecutive gettemp()s or for a one second time
interval. The host controller may also implement an alert to software in the event of a
critical or continuous fault condition.
6.3.2.4
PECI GetTemp0()Error Code Support
The error codes supported for the processor GetTemp0()command are listed in
Table 6-12
Table 6-12. GetTemp0() Error Codes
Error Code
0x8000h
0x8002h
below:
General sensor error
Sensor is operational, but has detected a temperature below its operational range
(underflow).
Description
§
91

Advertisement

Table of Contents
loading

Table of Contents